1. Home »
  2. เครื่องมือวัดละเอียด Measuring... »
  3. Gauge Blocks »
  4. MITUTOYO »
  5. 516-611 | Square Gauge Block A... »
Square Gauge Block Accessories Set
Square Gauge Block Accessories Set

516-611 | Square Gauge Block Accessories Set | MITUTOYO

MITUTOYO

Square Gauge Block Accessories Set

Order No. 516-611

Description :

To expand the application of square gauge blocks, Mitutoyo offers the Gauge Block Accessories Set. Square gauge blocks have a much broader range of application than rectangular gauge blocks due to the central clamping hole. Also, the accessories included in the set are sold individually depending on the application.

• It is recommended to use only Mitutoyo accessory sets with these gauge blocks as the tolerances on the assembly hole countersinks in the blocks and mating screw heads in the sets are 5 times tighter than the applicable standard, and therefore are guaranteed to fit together correctly.

ขอใบเสนอราคา
หมวดหมู่: , , ป้ายกำกับ: , , , , , ,

SPECIFICATIONS

Order No. :516-611
Metric / Inch :Metric
Included in set :Half round jaw 2 mm (619070)-2 pcs
Half round jaw 5 mm (619071)-2 pcs
Plain jaw (619072)-2 pcs.
Centre point (619073)-1 pc
Scriber point (619054)-1 pc
Block base (619074)-1 pc
Flat head screw 1·1/4" (619057)-2 pcs
Flat head screw 5/8" (619058)-2 pcs
Slotted head nut (619059)-2 pcs
Adjustable tie rod 6" (619060)-2 pcs
Adjustable tie rod 4·1/2" (619061)-2 pcs
Tie rod 3" (619062)-1 pc
Tie rod 2·1/4" (619063)-1 pc
Tie rod 1·1/2" (619064)-1 pc
Tie rod 3/4" (619065)-1 pc
Stud (619056)-2 pcs
Knurled head screw (619066)-2 pcs

Half-round jaw

Order No.R (mm)L (mm)W (mm)H (mm)
6190701.95233.65.3
6190714.95539.910.3

• Flatness 0.5 μm
• Parallelism of L 0.5 μm
• Tolerance of L ±0.5 μm

Plain jaw

Center point

Scriber point

Stud

Base

Slotted head nut

Knurled head screw

• Contraction caused by the clamping force

The minimum recommended torque to be applied to the clamping screws is approximately 600 mN·m. The chart below shows the approximate length contraction of a 100 mm gage stack using typical torque values.

DriverContraction
Torque Driver
600 mN·m		0.2 μm/100 mm
Ordinary Driver
700 to 800 mN·m		0.3 μm/100 mm

Flat head screw

Order No.L (mm)
61905731.6
61905815.8

Adjustable tie rod

Order No.L (mm)M (mm)P (mm)n (Number of holes)
619060124.53.856.3514
61906186.53.956.358

Tie rod

Order No.L (mm)
61906519
61906438
61906357
61906276

สินค้าที่เกี่ยวข้อง

611875-021 | Individual Metric Rectangular Gauge Blocks – 0.29mm | Mituto... 611876-021 | Individual Metric Rectangular Gauge Blocks – 0.31mm | Mituto...
error: Content is protected !!