Specification
Order No. | 177-248 |
---|---|
Nominal size ød (mm) | 3.0 |
Dimensions (mm) øD | 25 |
Dimensions (mm) øE | - |
Dimensions (mm) T | 7 |
Type | A |
Tolerance between the nominal size and the actual diameter (μm) | ±10 |
Uncertainty of marked diameter value*¹ (μm) | 1.5 |
Roundness / Cylindricity*² (μm) | 1.0 |
Distance from the side face H (mm) | 1.7 |
Size of warranted calibration surface K (mm) | 3.6 |
*1 Actual diameter is marked in 0.001 mm increments. (Dimension measuring position is the center of the height T.)
*2 Cylindricity is defined as per JIS B 0621 Definitions and designations of geometrical deviations, Section 4.4 “Cylindricity.”
Cylindricity is measured using three cross-sections between the top and bottom face of a ring, namely, close to the face near each side and the center.